Electrical Requirements; General Information - Viking 30” W Installation Manual

Electrical Requirements

WARNING
Electrical Connection
When making the wire connections, use
the entire length of the conduit provided
(3 feet). The conduit must not be cut.
Connect the red and black leads from the
unit conduit to the corresponding leads in
Electrical Requirements the junction box. The bare ground wire in the
Check your local codes regarding this unit. conduit is connected to the unit frame. When
This cooktop is supplied with a 3-wire, A.C. connecting to a 3-conductor branch circuit,
208V/120 volt or 120V/240 volt, 60 HZ connect the bare ground connector lead of
electrical system. A white (neutral) is not the unit to the branch circuit ground (bare
needed for this unit. See next section for wire or green in color).
grounding instructions. It should be fused
separately.
CAUTION
Refer to the specifications chart for kilowatt
rating and recommended amperage. House
wiring and fusing must comply with local
codes. If no local codes are applicable, wire
in accordance with the National Electrical
Code, ANSI/NFPA 70-latest edition.
12
WARNING
WARNING

General Information

READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION
WHEN INSTALLING THIS APPLIANCE.
• When removing the cooktop for service
• Keep appliance area clear and free from and/or cleaning, disconnect AC power
combustible materials, gasoline and other supply.
flammable vapors. • Electrical requirements are listed in the
• Disconnect the electrical supply prior to product specifications under the "Electrical
servicing or cleaning. Requirements" section.
Installation
1
Lower cooktop into cutout. Connect the red and black leads from the unit conduit
3
Countertop
Cooktop
Bracket
Screw brackets to burner box with sheet metal screw.
(Two bracket assemblies included)
13
2
Green
Ground
Red
Black
to the corresponding leads in the junction box.
4
Screw sheet metal screws into brackets
and tighten firmly against bottom of countertop.
Note: Be careful not to crack or damage
counter by overtightening.