Table of Contents
Advertisement
Open both the appliance door and that of the
kitchen unit to approx. 90°. Place the little plates
over the runners. Hold the doors of the appli-
ance and the unit together and mark the holes.
Remove the little plates and make the holes
with a diam. of 2 mm. Replace the little platee
over the runners and screw in the screws
provided (3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that
the doors of the appliance and the kitchen unit
open properly.
Inner door reversal
Using a screwdriver release bracket (1) by
pressing on the internal spring (Fig.) and
withdraw it from its seat together with the door;
remove plug (2) and fit it in the hole left open on
the opposite side;
turn the door through 180°, remove the bracket
(1) and refit it on the opposite side. Refit the
door and insert the top pin and bottom bracket
(1), pushing it into place.
To ensure correct storage of food, the door is
fitted with a simple spring device which holds it
in the open position until it is properly closed.
Electrical connection
Before plugging in, ensure that the voltage and frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For
operation with different voltages, a suitably sized auto-transformer must be used.
The technical data is indicated in the rating plate on the left side inside the appliance.
30
TECHNICAL SPECIFICATIONS
8mm
PR34
PR35
180
2
PR140
Fig. 9
Fig. 10
Fig. 11
1
GB
Advertisement
Table of Contents
