Table of Contents
Advertisement
3.4 Jumper Settings
JP14 Clear CMOS Data
You can clear CMOS to restore system default setting. To
clear the CMOS, follow the procedure below.
1. Turn off the system and unplug the AC power.
2. Remove ATX power cable from connector PWR2.
3. Locate JP14 and short pins 2-3 for a few seconds.
4. Return JP14 to its normal setting by shorting pin 1 & pin 2.
5. Connect ATX power cable back to connector PWR2.
1. Boot fails because of overclocking...
2. Forget password...
3. Troubleshooting...
31
Pin 1
1
Normal
(default)
JP14 Clear CMOS Jumper
Tip: When should I Clear CMOS?
1
Clear CMOS
Advertisement
Table of Contents
