Water Inlet; Drain; Electrical Connection - Electrolux EWT 1540 Instruction Book

3.5. Water inlet

This device (the aqua-control hose)
protects against water damage. The
water inlet hose may perish due to
natural wear : if this happens, this
device stops water entering the
appliance.
The fault is shown when a red mark appears in the window
«A». Turn off the water inlet tap and call the After Sales
Department.
Please install the water inlet hose onto the back of your
washing machine :
- Screw on the bottom fitting of the
water inlet hose as shown in fig.1
and fig.2.
- Connect the feed hose connector
onto the water inlet tap.
- Turn on the water inlet tap.
The water inlet hose cannot be extended. If it is too short,
please contact the After Sales Department.

3.6. Drain

- Assemble the hose holder onto the
drain hose.
- Place the assembly in a drainage
pipe (or in a sink) at a height
between 70 and 100 cm. Make sure
that it will not fall out.
You must provide an air intake at the end of the drainage
hose, to avoid any water being siphoned.
Important: the drainage hose must not be extended, on
any account. If it is too short, contact a qualified engineer.

3.7. Electrical connection

You can only connect this washing machine to 230 V sin-
gle phase power supply.
Check rating of the fuse line: 10 A at 230V.
The washing machine must not be connected through an
extension cable or a power bar.
Check that the earthing connection is conform with the re-
gulations in force.
38