Maintenance - Electrolux CS 110 Installation & Operating Instructions Manual

maIntenance

We recommend that you keep your wine cellar as
clean as possible. Unplug the cellar before clean-
ing. Do not use any abrasive or strong scented
substances. Use a smooth cloth or sponge and light
detergent.
It is very important to check regularly that the air
circulation underneath and behind the cellar is not
blocked.
Condensation collects in a small cup placed at
the back of the wine cellar. The cup has a sponge
which helps the condensation to evaporate. Check
that the plastic pipe routing the water from the
inside to the cup is not blocked by dust or dirt.
You should replace the inside ventilation charcoal
filter every second year. The filter is fitted in the
upper left corner inside the wine cellar.
If the wine cellar fails to work, check the following
points before calling a service technician:
• Is the fuse of power supply intact?
• Is the plug properly inserted in its socket?
• Is the wine cellar switched on?
If the cause of failure is not to be found among the
points listed above, contact an authorised service
technician.
The wine cellar is equipped with an overheating
protection. An authorised service technician can
check whether this has been triggered or not.
InstallatIon of guIdes and shelf
supports
slIdIng shelves
Place the rear hook of the guide in front of the
desired hole in the rear row and push in direction
of arrow 1. Then, do the same with the front hook
(arrow 2).
shelf support for storage shelf
Place the support hooks in the holes at desired
level, press in as arrow 1 indicates and push down
as arrow 2 indicates.
1
Reinforcement bar
The reinforcement bar is a shelf support and must
not be removed for safety reasons.
REINFORCEMENT bAR
KIts
Each kit contains two shelves and shelf supports.
Sliding shelf kit number:
Storage shelf kit number:
Model Max. no. of sliding shelves
CS 110 8 (wooden door) / 9 (glass door)
CS 160 12
CS 200 16
- 5 -
2
1
2
921 17 81-99
921 17 81-98