Table of Contents
Advertisement
III. Integration Procedures
Installing SCSI devices
Next to previous section, the integrated drive bay shown on Fig: 3-23. Then
place the SCSI device on to drive bay and connect necessary cables from
both drive bay and slot card to SCSI device including SCSI cable, power
cable, access status cable and SCSI ID cable. Especially be sure the 8-pin
SCSI ID cable is connecting with correspondent SCSI ID on both SCSI
drive and slot card (Fig: 3-24). Finally screw in the SCSI drive with drive
bay (Fig: 3-25).
Fig 3-23: Integrated Drive Bay
Fig 3-24: Necessary Cables Connect to SCSI device both Front and Back.
Fig 3-25: Screw in device on Drive Bay
Drive locations
The recommendation of drives location is that first top drive used for floppy,
second for CD-ROM and the rest could be used for Hot-Swap drive bays
(Fig: 3-26). All the devices either carried on Hot-Swap drive bay or Fixed-
Type driver bay, should be inserted to housing from the front of housing.
24
ASUS AP5000 Installation Guide
Advertisement
Table of Contents
