Remote Control Features - JEFF ROWLAND Coherence Owner's Manual

Remote Control Features

The six-function, hand-held, IR remote transmitter permits remote
A
operation of Input Selection, Volume Up/Down, Balance L/R and
Mute functions
A separate remote sensor/display unit simultaneously receives
B
transmitted data and displays the numerical Volume control position
from 0 to 63.5 dB in increments of 0.5 dB.
The supplied RJ-11 cable allows the remote sensor/display unit to be
C
placed within two meters of the preamplifier for optimal IR reception
and/or volume control position viewing. Up to 30 meters of cable
length can be used if desired.
The Interconnect Cable Adapter should first be connected securely to
D
the DB-25 connector on the rear panel of the Power Supply using the
integral finger screws. The RJ-11 cable can then be installed from the
Remote Sensor/Display unit to the adapter.
After installing the remote sensor/display unit and associated connecting
cable, reset the preamplifier by pressing the power supply MODE
switch and holding it for at least 5 seconds. Then release to commence
operation.
The remote transmitter handset operates on a standard 9 volt battery
available from a wide variety of sources. This battery is accessed by
removing the two Phillips head screws on the back side of the handset.
Four (4) different data rate transmission codes can be selected if inter-
ference from other IR remote transmitters become an issue. Simply match
the switch code between both handset and remote receiver/display unit
internal switches (accessed by removing the respective bottom covers).
A
B
D
C