Ignition And Shut-Down - Ferroli ECONCEPT 50 A Installation And Operating Instructions Manual

Operating indications on the display
During operation, without pressing any of the buttons the display shows the operating status of the
appliance:
Standby
Heating
Domestic hot water
Standby following domestic hot water op.
Standby following heating op.
Waiting for DHW production
Note: when the burner fires a small. Will appear in display D1 after the letter.
Accessing the operating menu
Pressing the "
displays the following parameters and information in sequence:
DISPLAY D1

1.3 Ignition and Shut-down

Ignition
Check that any shut-off valves in the heating system and domestic hot water circuit outside of the boiler are
open. Open the gas control upstream from boiler and press the main switch. The boiler will perform a self-
test cycle lasting approximately one minute, at the end of which it is ready for operation. The ignition and
shut-down of the burner assembly are completely automatic operations, which depend on the requirements
of the heating system or domestic hot water circuit (display should read "FHI" during test).
6
Operating mode
- mode" button once accesses the operating menu. Pressing the "
DISPLAY D2/D3
Summer/Winter Selection (00 = Summer - 11 = Winter)
Economy/Comfort Selection (0 = Economy - 1 = Comfort)
CH outlet temperature view and setting
Display and setting DHW storage temperature
Display system return temperature
External temperature
Flue gas temperature
-
-
Boiler power
Compensation curve setting
-
Display "D1" Display "D2/D3"
Central heating outlet temperature
Central heating outlet temperature
Domestic hot water temperature
Domestic hot water temperature
Central heating outlet temperature
Domestic hot water temperature
Econcept 50 A
- mode" button again