Husqvarna LR122 Owner's Manual page 19

TO REPLACE MOTION DRIVE BELT
(See Fig. 22)
The tractor drive belt may be replaced without tools. Park
the tractor on level area. Engage parking brake. For
assistance, there is a belt installation guide decal on bottom
side of left footrest.
• Engage parking brake.
• Lower attachment lift lever to "lowest" position.
• Turn front wheels fully to left or right.
• Disconnect mower drive belt at engine pulley.
• Disconnect motion drive belt at clutching idler.
• Disconnect motion drive belt at transaxle. Push above
transaxle pulley.
• Disconnect motion drive belt at frame belt keeper.
• Disconnect motion drive belt at engine pulley. Thread
belt below mower drive sheave and through engine belt
keeper and engine pulley.
• Remove belt.
• Install new belt by reversing above procedure.
• Make sure that belt is inside all belt keepers.
IMPORTANT: REPLACE ONLY WITH SPECIFIED BY
ORIGINAL EQUIPMENT MANUFACTURER.
MOWER
DRIVE
SHEAVE
CLUTCH
PEDAL
SHAFT
MOWER LIFT
SHAFT
CLUTCHING
IDLER
SERVICE AND ADJUSTMENTS
ENGINE
PULLEY
MOWER
DRIVE
BELT
ENGINE
BELT
KEEPER
FRAME BELT
KEEPER
TRANSAXLE
PULLEY
FIG. 22
TO ADJUST STEERING WHEEL ALIGNMENT
If steering wheel crossbars are not horizontal (left to right)
when wheels are positioned straight forward, remove steer-
ing wheel and reassemble per instructions in the Assembly
section of this manual.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not adjustable on
your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.
TO REMOVE WHEEL FOR REPAIRS
(See Fig. 23)
• Block up axle securely.
• Remove axle cover, retaining ring and washers to allow
wheel removal (rear wheel contains a square key - Do
not lose).
• Repair tire and reassemble.
• On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key.
• Replace washers and snap retaining ring securely in
axle groove.
• Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to
slow leaks, tire sealant may be purchased from your local
parts dealer. Tire sealant also prevents tire dry rot and
corrosion.
WASHERS
RETAINING
RING
AXLE COVER
SQUARE KEY
(REAR WHEEL ONLY)
19
FIG. 23