Advertisement
• The electrical cord of this product cannot be replaced. If it sustains
damage, you must stop using the appliance immediately and
return it to the HoMedics Service Center for examination and
repair. (See the warranty section for HoMedics address).
• Disconnect the appliance from the electrical outlet before putting
hands into water.
Assembly and Instructions for Use
1. Remove all contents from packaging and inspect to make sure
all components have been received (Fig. 1):
• Base with attached electrical cord and water pump
• Fountain top
• Polished river rocks
• A/C Adaptor
2. Wipe any dust off the interior and exterior of the base and top
and rinse river rocks under water.
3. Familiarize yourself with the pump. The pump speed is
controlled by the dial located at the front of the pump. The speed
is indicated by a "-" and "+". To increase the speed, move the
dial downward in the direction of the "+". At its highest speed
level, the dial will cease to move any further. To decrease the
pump speed, move the dial upward toward the "-". Similarly, at
its lowest speed, the dial will cease to move any further (Fig. 2).
Figure 1
Fountain Top
Fountain Base
Polished Rocks
4
Figure 2
Figure 3
Figure 4
PVC Tube
Fountain Pump
Power Cord
A/C Adaptor
4. Place the fountain base on a sturdy, level surface
-
+
5. Add clean water to the base until the water level
6. Connect the PVC tube to the pump, adjust the
Cord Notch
Fountain Base
7. Place the fountain top on to the base and then
8. Plug the A/C adaptor into a 120V household outlet.
PVC Tube
Fountain Pump
9. It will be necessary to add water occasionally due
NOTE: It is recommended the pump be set at its
highest speed during assembly and later adjusted
to a lower setting if desired. Be sure to unplug the
pump before adjusting the speed setting.
in the desired location, ensuring its electrical cord
will sufficiently reach an electrical outlet. Once
assembled, the fountain may be difficult to move
due to splashing. Once in the desired location,
lead the power cord attached to the base through
the notch at the bottom of the base to ensure the
base sits level without wobbling. Attach the A/C
adaptor jack to the base power cord. Do NOT plug
in at this time (Fig. 3).
is 1/2" to 3/4" below the rim.
pump speed and place the fountain top on the
base (Fig. 4).
arrange the polished river rocks around the
fountain top. (Be sure not to place any rocks
inside the base of the fountain).
The fountain is controlled by the switch located on
the power cord. If pump doesn't operate, rotate in-
line switch once to turn "on" and once more to turn
"off".
NOTE: If you can hear the pump gurgling or making
sounds, you have not added enough water to cover
(submerge) the pump.
to evaporation.
NOTE: Always add water when fountain is "OFF"
to avoid overflow.
5
Advertisement
