RX3041H User's Manual
11.5.2 Configuring SNMP
1. Open the SNMP configuration page by clicking the System
Management
2. Click on the "Enable" or "Disable" radio button to enable or disable the
SNMP support.
3. Enter the RO (Read Only) and RW (Read and Write) community names.
4. Enter the IP address of the SNMP management station that receives
trap messages from the RX3041H.
5. Click on
SNMP configuration table displayed at the bottom of the configuration page.
11.6 System Configuration Management
11.6.1 Reset to Factory Settings
11.6.1.1
Reset to Factory Settings Using Configuration Manager
At times, you may want to revert to the factory default settings to eliminate
problems resulted from incorrect system configuration. Follow the steps below
res
et system co
nfiguration:
1. Open the Default Setting configuration page by clicking the System
Management
2. Click on
factory default settings. Note that the RX3041H will reboot to make the
factory default configuration in effect.
3. A count down timer will popup as shown below.
SNMP menu.
Figure 11.7. SNMP Configuration
button to save the configuration. You can verify your settings in the existing
Figure 11.8. Existing SNMP Configuration
Configuration
Default Setting menu.
button to set the system configuration back to the
Figure 11.9. Default Setting Configuration
Chapter 11. System Management
to
99