Ac / Dc Adapter; Remote Sensor Rtgr328Na; Set Up Sensor - Oregon Scientific WRB603 User Manual

AC / DC ADAPTER

Insert the adapter into the weather station to turn it on
and allow charging for the radio.
REMOTE SENSOR (RTGR328NA)
This remote temperature-humidity sensor can receive
and transmit atomic clock signals, collect outdoor
temperature and humidity readings, and then relay them
back to the weather station. It can be used with up to 4
other remote temperature-humidity sensors.
NOTE Additional remote sensors that measure
temperature and humidity are sold separately.

SET UP SENSOR

1. Open the battery compartment with a small Phillips
screwdriver.
2. Set the channel number (1-5). If you are using
more than one remote unit, select a different
channel number for each unit
WRB603_EN_R0
3.
4.
5. Press RESET.
6.
7. Secure the sensor in the desired location using the
For best results:
•
•
•
9
9
Insert the batteries.
Set the measurement unit (°F or °C) and select the
US time zone – Pacific (P), Mountain (M), Central
(C) and Eastern (E).
Replace and secure the battery compartment lid.
wall mount or table stand.
Insert the batteries and select the channel
before you mount the sensor.
Place the sensor out of direct sunlight and moisture.
Do not place the sensor more than 98 feet (30 meters)
from the weather station.
27/6/07, 3:31 PM