Product View And Features - Generac Power Systems 7500 Owner's Manual

Generac Portable Products 7 500EXL Extended L ifeGenerator
KNOW YOUR GENERATOR
Read this owner's manual and safety rules before operating your generator.
Compare the illustrations with your generator to familiarize yourself with the locations of various controls and
adjustments. Save this manual for future reference
Circuit Breakers (AC)
12 Volt DC
Receptacle
Idle Control Switch
Electric Start Button
Recoil Starter
Choke Lever
120 Volt AC,
30 Amp Locking
Receptacle
/
120/240 Volt AC, 30 Amp /
Locking Receptacle
/
120 Volt AC, 20 Amp
Receptacles
Grounding Wing Nut
Run/Stop Switch
Spark Arrestor Muffler
240 Volt AC, 50 Amp
Receptacle
12 Volt DC Receptacle i Use this receptacle with
battery charge cables to charge a 12 Volt battery.
120 Volt AC, 20 Amp Receptacles May be used to
supply electrical power for the operation of 120 Volt
AC, single phase, 60 Hz electrical lighting, appliance,
tool and motor loads.
120 Volt AC, 30 Amp Locking Receptacle i May be
used to supply electrical power for the operation of
120 Volt AC, 30 Amp, single phase, 60 Hz electrical
lighting, appliance, tool and motor loads.
120/240 Volt AC, 30 Amp Locking Receptacle --
May be used to supply electrical power for the
operation of 120 and/or 240 Volt AC, 30 Amp, single
phase, 60 Hz electrical lighting, appliance, tool and
motor loads.
240 Volt AC, 50 Amp Receptacle i May be used to
supply electrical power for the operation of 240 Volt
AC, 50 Amp, single phase, 60 Hz electrical loads.
Choke Lever Used when starting a cold engine.
Circuit Breakers (AC) -- Each receptacle is provided
with a "push to reset" circuit breaker to protect the
generator against electrical overload.
Electric Start Switch -- Pressed to start the engine.
Grounding Wing Nut -- Use this connection to
properly ground the generator.
Idle Control Switch -- The idle control runs the
engine at normal (high) speeds when there is a load
present and runs the engine at idle (low) speeds when
a load is not present.
Recoil Starter = Used as an alternate means of
starting the engine.
Run/Stop Switch -- Must be in "Run" position to start
engine. Set to "Stop" to stop a running engine.
Spark Arrestor Muffler-- Exhaust muffler lowers
engine noise and is equipped with a spark arrestor
screen.
/
4