Table of Contents
Advertisement
Something not working
30 electrolux
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that the red Start/Pause pilot light flashes
and one of the following alarm codes appears on the display to indicate that the
machine is not working:
E10
: problem with the water supply
●
E20
: problem with water draining
●
E40
: door open
●
Once the problem has been eliminated, press the Start/Pause button to restart
the programme. If after all checks, the problem persists, contact your local
Service Centre.
Malfunction
The washing machine does
not start:
The machine fills then
empties immediately:
The machine does not fill:
Possible cause
The door has not been
●
E40
closed.
The plug is not properly
●
inserted in the power
socket.
There is no power at the
●
socket.
The main fuse has blown.
●
The selector dial is not
●
correctly positioned and the
Start/Pause button has not
been depressed.
The «Delay» has been
●
selected.
The end of the drain hose is
●
too low.
The water tap is closed.
●
E10
The inlet hose is squashed or
●
E10
kinked.
)
The filter in the inlet hose is
●
E10
blocked.
The door is not properly
●
E40
closed.
Solution
Close firmly the door.
●
Insert the plug into the
●
power socket.
Please check your domestic
●
electrical installation.
Replace the fuse.
●
Please turn the selector dial
●
and press the Start/Pause
button again.
If the laundry are to be
●
washed immediately, cancel
the delay start.
Refer to relevant paragraph
●
in "water drainage" section.
Open the water tap.
●
Check the inlet hose
●
connection.
Clean the water inlet hose
●
filter.
Close firmly the door.
●
Advertisement
Table of Contents
