Operation Examples; Menu Tree - Crown I-T4000 Operation Manual

I-Tech Series Power Amplifiers
4 Advanced Operation

4.2.5 Operation Examples

Operation Example 1
How to set the CH1 input sensitivity using the LCD Control Screen:
1. After power-up, press Menu/Exit. The first menu item appears:
the Contrast screen.
2. Press Next until you see "CH1 Sensitivity."
3. Turn an Encoder to set the sensitivity. NOTE: If you do not see
the sensitivity you want, try changing the Maximum Analog Input
level (see below).
4. Press Menu/Exit.
Operation Example 2
How to set the Maximum Analog Input level using the LCD Control
Screen:
1. After power-up, press Menu/Exit. The first menu item appears:
the Contrast screen.
2. Press Prev until you see "Advanced Menu."
3. Push an Encoder knob.
4. Press Next until you see "Maximum Analog Input."
5. Press an Encoder to change the maximum analog input level.
6. Press Menu/Exit.
Operation Example 3
How to monitor the Thermal Errors using the LCD Control Screen:
1. After power-up, press Menu/Exit. The first menu item appears:
the Contrast screen.
2. Press Prev. You will see "Monitor Menu."
3. Push an Encoder knob.
4. Press Next until you see "Thermal Errors."

4.2.6 Menu Tree

As a handy reference, Figure 4.2 shows the menu structure of the
LCD control screen. Once you are in a menu, you can loop through
its selections using the Next and Prev buttons. The Menu/Exit
button returns you to the Attenuation screen which you see on
power-up.
You access the Monitor Menu title screen from the Attenuation
screen by pressing Menu/Exit > Prev. You access the Advanced
Menu title screen from the Attenuation screen by pressing
Menu/Exit > Prev > Prev.
Operation Manual
MENU TREE
Attenuation - Mute - Lockout
Menu button
BASIC MENU
Contrast (Prev goes to
Monitor Menu)
CH1 Sensitivity Next
CH2 Sensitivity
Presets
Output Mode
Input Y
Me/You Amp Finder
Advanced Menu screen
Exit Monitor Menu screen
ADVANCED MENU
(press knob to access these
items:)
Attenuator Limits
Attenuator Link
LED Meter Display Type
Next
Bar Meter Display Type
Clip Limiter
Peak Voltage Limiter
Average Power Limiter
Exit
Pink Noise Generator
AES/EBU Input Trim
Input Source
Maximum Analog Input
MONITOR MENU
(press knob to access these
items:)
Load Monitoring
Thermal %
Next
AC Voltage
Operating Time
Firmware
Manufacturing Info
Networking
Exit
Clip Errors
Thermal Errors
Low Limit Load Errors
High Limit Load Errors
Line Voltage Errors
Figure 4.2 Menu Tree of the I-Tech LCD Control Screen
Prev
Prev
Prev
page 21