Table of Contents
Advertisement
Washing Program Progress
Program Sequence Display
Prior to the start, the program steps chosen are
displayed by the program sequence display. During
the washing program the current program step is
displayed.
Multi-display
The expected time remaining (in minutes) to the end
of the program is shown in the multi-display.
The multi-display indicates the estimated
3
duration, in minutes, of the program. These
timings are estimates and can be varied and
influenced by incoming water temperature,
type and quantity of laundry, out of balance
spin detection and foam detection. During
the program countdown the remaining time
can be recalculated due to any of the above
factors.
Changing the Spin Speed
During the washing program, the spin speed can still
be changed or the RINSE HOLD (Spülstopp, Arrêt
Cuvé Pleine) can be set.
Other settings cannot be changed.
Stopping the programme
Turn the program selector to OFF (Aus, Arrêt) in order
to stop the washing program prematurely.
The washing program can be interrupted at
3
any time with the START/PAUSE (Marche/
Pause) button and can be continued again
by pressing this button again.
Washing Cycle Ended/Remove Washing
After a washing program has ended, END (Ende, Fin)
lights up on the program sequence display.
• A crease protection phase of approx. 30 minutes
follows at the end of the program if program
EASY IRON (Leichtbügeln, Fâcile à Repasser) had
been selected. The multidisplay also shows a
remaining time and the display END (Ende, Fin) is
illuminated. You can open the filling door and take
the washing out at any time during the crease
protection phase..
• If you selected RINSE HOLD (Spülstopp, Arrêt
Cuvé Pleine), the indicator next to the button
START/PAUSE (Marche/Pause) flashes.
ve Washing
19
Advertisement
Table of Contents
