Electrolux Swissline GL EWF 1280 User Information page 20

Problem
E10 appears.
END indicator flashes 1x,
at the same time an
acoustic signal sounds
1x.
(Problems with water in-
flow.)
Washing machine vi-
brates when operating or
is noisy.
Washing has not been
spun.
Water is leaking out un-
derneath the washing ma-
chine.
EF0 appears. END indica-
tor flashes 15x, at the
same time an acoustic
signal sounds 15x.
The drain pump runs con-
stantly, even when the
machine is switched off.
Washing water is foaming
excessively. At the end of
the washing cycle, the
spin stops. OVER DOS-
ING indicator is lit.
20
Possible cause
Tap turned off.
Filter in the screw connection
of the inlet hose is blocked.
Water tap is blocked with
limescale or faulty.
Transport lock has not been
removed.
Screw feet not correctly ad-
justed.
Only a few large items of
washing in the drum.
Screw connection on the inlet
hose is leaking.
Drain hose is leaking.
Drain pump cover is not
closed properly.
Washing was caught in the
door.
Emergency drain hose is leak-
ing.
The Aqua Control anti-flood
system has responded.
Probably too much detergent
has been used.
Remedy
Turn the tap on.
Turn off the water tap. Unscrew
hose, take out filter and clean it.
Check the water tap and have it
repaired if necessary.
Remove transport lock.
Adjust feet according to the In-
stallation and Connection in-
structions.
Always load the drum as full as
possible. Mix large and small
items.
Tighten inlet hose.
Replace drain hose.
Close cover properly.
Load washing carefully for the
next wash.
Close off emergency drain hose
properly.
Turn off the tap, remove the
mains plug from the socket and
contact the Customer Care De-
partment.
Dose detergent exactly as in-
structed by manufacturer.