Electrolux EWF 1249 Instruction Booklet page 13

7 START/PAUSE button
This button has 2 functions:
Start: after you have selected the desired
programme and options, press this button to
start the washing machine. The light close to the
button will stop flashing and remain lit.
If you have selected a delay time option, the
countdown will begin and will be shown on the
display.
Pause: when you press this button again, the
programme in progress is interrupted. The light
close to the button will start flashing. To restart
the programme, press the button again.
When you PAUSE the cycle, it becomes possible to
open the door if:
The washing machine is not in the heating
phase;
The level of the water is not high;
The drum is not turning.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
8 Vocal messages
An electronic vocal board helps you through all the
wash process, with its clear, simple and helpful
messages.
The vocal messages can be activated or
disactivated, pressing simultaneously the buttons
«Change» and «Exit». If it's activated on the display
is written "Voice enable". If it's disactivated on the
display is written "Voice disable".
It is possible the select three different levels of
volume (LOW, MED and MAX), by pressing the
«Change» button, entering in SETUP and then on
setup option.
When the appliance is switched on, a frielndly jingle
can be heard.
There are two kind of messages:
messages explaining how to set a washing
programme up and describing the different
options.
The messages can be heard only once some
seconds after a new selection.
warning messages.
In these case, the messages are played immediately
and repeatedly until the cause is removed.
Note! This vocal board can speak several
languages. You can choose the machine speaking
language in the same way you select the one
appearing on the display. If you choose a language
not provided, no message is played.
13