Questions And Answers - Gigaset C580 Manual

Questions and answers

If you have any questions about using your
phone, visit us at www.gigaset.com/custom-
ercare at any time. The table below contains
a list of common problems and possible
solutions.
The display is blank.
¥
1. The handset is not switched on.
Press and hold the end call key
2. The batteries are flat. ¥
¢
Charge or replace the batteries
( page 9).
Base
" " flashes in the display.
1. The handset is outside the range of the base
¥
station.
Move the handset closer to the base sta-
tion.
3. The base station is not turned on. ¥
¢
Check the base station's mains adapter
( page 7).
Handset does not ring.
1. The ringer is deactivated. ¥
Activate the ringer (
You cannot hear a ringer/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
¥
pin connections.
Please always use the phone cord supplied or
ensure that the pin connections are correct
¢
when purchasing from a retailer
( page 48).
a
.
¢
page 37).
Error tone sounds after system PIN prompt.
¥
You have entered the wrong system PIN.
Reset the system PIN to 0000 (
Forgotten the system PIN.
¥
Reset the system PIN to 0000 (
The other party cannot hear you.
You have deactivated the microphone.
¥
The handset is "muted".
Activate the microphone again (
The number of the caller is not displayed
despite CLIP.
¥
Calling Line Identification is not enabled.
The caller should ask the network provider to
release Calling Line Identification (CLI).
You hear an error tone (descending tone
sequence) when inputting.
¥ Action has failed/invalid input.
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
You cannot listen to messages on the network
mailbox.
¥
Your PABX is set for dial pulsing.
Set your PABX to touch tone dialling.
Gigaset C585 only:
No time is specified for a message in the
answer machine history.
¥ Date/time is not set.
Set the date/time (
The answer machine announces "PIN is incor-
rect" during remote operation.
1 ¥ You have entered the wrong system PIN.
.
Enter the system PIN again.
¥
2 The system PIN is still set to 0000.
.
Change the system PIN (
The answer machine will not record any mes-
sages.
¥
Its memory is full.
¥
Delete old messages.
Play back new messages and delete.
Service Centres
¢
page 38).
¢
page 38).
¢
page 22).
¢
page 12).
¢
page 38).
45