If The Wash Results Are Not Satisfactory - Electrolux Swissline GL EWF 1387 User Information

Problem
E20 appears.
END indicator flashes 2x,
at the same time an
acoustic signal sounds
2x.
(Problems with water out-
flow.)
Conditioner not rinsed in,
w compartment for addi-
tives is filled with water.
Door cannot be opened
when appliance is
switched on.
Washing is heavily
creased.

If the wash results are not satisfactory

Washing is grey and scale is being deposited in the drum
• Too little detergent is being used.
• The right detergent was not used.
• Special soiling was not pre-treated.
• Programme or temperature was not correctly set.
There are grey stains on the washing.
• Washing soiled with ointment, grease or oil was washed with too little de-
tergent.
• It was washed at too low a temperature.
• A common cause is that fabric conditioner – especially a concentrate –
has got onto the washing. Such stains should be washed out as quickly
as possible and make sure that you are careful when using fabric condi-
tioner.
Possible cause
Kink in the drain hose.
Maximum pumping height of
1m exceeded.
Drain pump is blocked.
With connection to sink outlet:
sink outlet is blocked.
Conditioner insert in the com-
partment for additives is not
correctly attached or is
blocked.
Door locked.
Power cut. (All display indica-
tors are off.)
Door remains locked for 4 to
10 minutes.
Possibly too much washing
was loaded.
Remedy
Remove kink.
Please contact the Customer
Care Department.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove for-
eign bodies from pump hous-
ing.
Clean out sink outlet.
Clean detergent dispenser
drawer, insert conditioner in-
sert firmly.
Wait until DOOR indicator is lit
green.
Programme continues, when
power cut is over.
To remove washing:
If water can be seen in the ap-
pliance, before opening the
door, first drain off the water.
(See section "Carrying out an
emergency drain".)
Observe maximum loads.
21