Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Electrolux DI 8821
Summary of Contents for Electrolux DI 8821
- Page 1 DI 8821 Cooker Hood Operating and Installation Instructions...
-
Page 2: Table Of Contents
Contents Safety warnings ................3 For the user ..................3 For the installer ................... 4 Description of the Appliance ............6 Extraction version ................6 Recirculation Version ................6 Control Panel ..................7 Grease and charcoal filter maintenance indicator ....... 8 Maintenance and Care .............. -
Page 3: Safety Warnings
Safety warnings For the user • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. -
Page 4: For The Installer
For the installer • When used as an extractor unit, the hood must be fitted with a 150mm diameter duct. • When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces: electric cookers 500 mm... - Page 5 - short and straight outlet ducting - keep bends in outlet ducting to a minimum - never install the ducts with an acute angle, they must always follow a gentle curve. - keep the duct as large as possible (preferably the same diameter as the outlet hole).
-
Page 6: Description Of The Appliance
Description of the Appliance • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • The hood is supplied as an extractor unit and can also be used with a recirculation version by fitting a charcoal filter. Extraction version •... -
Page 7: Control Panel
Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. -
Page 8: Grease And Charcoal Filter Maintenance Indicator
Grease and charcoal filter maintenance indicator This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. -
Page 9: Maintenance And Care
Maintenance and Care • The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood • Clean the outside of the hood using a damp cloth and a mild deter- gent. • Never use corrosive, abrasive or flammable cleaning products. •... -
Page 10: Charcoal Filter
Charcoal filter • The charcoal filter should only be used if you want to use the hood in the recirculation function. • To do this you will need an original charcoal filter (available from your local Service Centre). • Cleaning/replacing the charcoal filter Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. -
Page 11: Changing The Light Bulb
Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. -
Page 12: Something Not Working
Something Not Working If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood Check that: The hood is connected to will not start... the electricity supply. Check that a fan speed has been selected The cooker hood Check that: The fan speed is set... -
Page 13: Technical Specifications
Technical Specifications Dimensions (in cm): Height 91-134 Width Depth Maximum absorbed power (W): Motor (W): Lighting (W): 4 x 20 Length of the cable (cm): Electrical connection (V): Mounting accessories included 1 Deflector (3 pieces) 1 allen spanner (for TORX screws). 6 Wood-screws 6 x 70 mm 6 Wall plugs Ø... -
Page 14: Installation
Installation - Fig. 7-8-9-10 Assembling the deflector (3 parts – only for filter version): The three parts should be fixed with 2 screws, the deflector extension is adjustable and should correspond to the width of the chimney flue support, to which it is then fixed. Fig. 7. Expansion plugs are provided to secure the hood to most types of ceilings. - Page 15 • Adjust extension of the hood support structure, as the final height of the hood depends on this, and remember that with installation completed the hood must be at least 50 cm above the hob top for electric cookers and 65 cm for gas or mixed fuel cookers. •...
- Page 16 Fig. 8...
- Page 17 • For extractor versions (13A), connect the other end of the exhaust pipe to the flue. For filter versions (13F), fit deflector F to the support and secure it to the bracket supplied using 4 screws, then connect the exhaust pipe to the connection ring located on the deflector.
- Page 18 Fig. 9...
- Page 19 Fig. 10...
- Page 20 From the Electrolux Group. The world´s No.1 choice. The Electrolux Group is the world´s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx.