Electrolux EWF 1210 Instruction Booklet page 13

132990040 gb.qxd 07/11/2003
7. Select the DELAY START
Before you start the programme, if you wish the
starting to be delayed, press the DELAY START
button repeatedly, to select the desired delay. The
relevant light illuminates.
H
H
8. Start the programme
To start the selected programme, press the
START/PAUSE button
light stops flashing and remains lit.
The light illuminates.
If you have chosen a delayed start, the machine will
begin the countdown.
9. Altering the programme
You can alter the programme before it starts.
When the programme has started, you can only
reset it by turning the programme selector dial
to O and then you can select the new
programme.
The washing water remains in the tub.
Start the new programme by depressing the
START/PAUSE button
10. Interrupting a programme
Depress the START/PAUSE button
a programme which is running, the corresponding
light starts to flash. Depress the button again to
restart the programme.
11:00 Pagina 13 (Nero/Process Black pellicola)
, the corresponding
.
to interrupt
11. Cancelling a programme
Turn the selector dial to O to cancel a programme
which is running. Now you can select a new
programme.
12. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
START/PAUSE button .
If the door does not open, this means that the
machine is already heating, that the water level is
above the bottom edge of the door or that the drum
is turning.
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
selector dial to "O". After about 3 minutes the door
can be opened (pay attention to the water level and
temperature!).
13. At the end of the programme
The machine stops automatically.
The START-PAUSE pilot light goes out and the
END pilot light comes on. The door can be
opened.
If the Rinse Hold option has been selected, the
relative pilot light remains lit and the door is locked
to indicate that the water must be emptied out
before opening the door.
To do this turn the programme selector dial to "O"
and then to programme
spin). The spin programme is performed at the
maximum speed.
Switch the machine off by turning the programme
selector dial to "O".
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
13
(drain) or (short