Setting The Audio Options - Pioneer SX-319V Operating Instructions Manual

Listening to your system

Setting the Audio options

There are a number of additional sound
settings you can make using the AUDIO
PARAMETER menu. The defaults, if not stated,
are listed in bold.
Important
• The AUDIO PARAMETER menu is not
available with MULTI IN input (see
Selecting the multichannel analog inputs
on page 29).
• Note that if a setting doesn't appear in the
AUDIO PARAMETER menu, it is
unavailable due to the current source,
settings and status of the receiver.
Setting What it does
S.DELAY
Some monitors have a slight delay when showing video, so
(Sound Delay) the soundtrack will be slightly out of sync with the picture.
By adding a bit of delay, you can adjust the sound to match
the presentation of the video.
a
Allows you to hear effective surround sound of movies at
MIDNIGHT
low volumes.
a
Used to get good bass and treble from music sources at
LOUDNESS
low volumes.
b
When audio data is removed during the compression
S.RTV
process, sound quality often suffers from an uneven sound
(Sound Retriever)
image. The Sound Retriever feature employs new DSP
technology that helps bring CD quality sound back to
compressed 2-channel audio by restoring sound pressure
and smoothing jagged artifacts left over after
compression.
c
Specifies how dual mono encoded Dolby Digital
DUAL MONO
soundtracks should be played.
RECEIVER
INPUT SELECT SOURCE
ZONE 2
RECEIVER
ON/OFF TV CONTROL
INPUT
BD TV DVR
CH
CD CD-R TUNER
1 Press RECEIVER on the remote control,
then press AUDIO PARAMETER button.
Use / to select the setting you want
2
to adjust.
Depending on the current status/mode of the
receiver, certain options may not be able to be
selected. Check the table below for notes on
this.
Use / to set it as necessary.
3
See the table below for the options available
for each setting.
4 Press RETURN to confirm and exit the
menu.
AUDIO AUDIO TUNER EDIT MASTER
PARAMETER PARAMETER TOOLS VOLUME
TOP MENU
MENU
ENTER
HOME
MENU BAND
SETUP RETURN RETURN
Option(s)
0.0 to 9.0 (frames)
1 second = 30 frames
(NTSC)
Default: 0.0
M/L OFF
MIDNIGHT
LOUDNESS
OFF
ON
CH1 –
Channel 1 is heard only
CH2 –
Channel 2 is heard only
CH1 CH2 –
Both channels heard
from front speakers
05
27
En