Installation; Rack Mounting (Xl1600 Only); Audio Connectors - Behringer Xenyx XL1600 User Manual

3.

Installation

3.1

Rack mounting (XL1600 only)

The packaging of your XL1600 contains two 19" rack mounts that
can be fastened to the side panels of the console.
Before you can attach the rack mounts to the mixing console,
you need to remove the screws holding the left and right side
panels. Then, use these screws to fasten the two rack mounts,
each specifically to one side. After attaching the rack mounts, you
can mount the mixing console in a standard 19" rack. Be sure
to allow for proper air flow around the unit, and do not place the
mixing console close to radiators or power amps, so as to avoid
overheating.
Only use the screws holding the mixing console side
+
panels to fasten the 19" rack mounts.
3.2

Audio connectors

The " inputs and outputs of the BEHRINGER XENYX mixer are
¼
unbalanced mono TS connectors except for the balanced Line
inputs on the mono and stereo channels as well as the Main Out
connectors. Of course, you can use the mixer with balanced as well
as unbalanced " connectors. The CD/TAPE inputs and outputs
¼
are stereo RCA connectors.
+ Make sure that only competent people install your mixer.
They must be sufficiently grounded during and after the
installation process. Otherwise, electrostatic discharges
may negatively affect the operating characteristics of
your equipment.
Fig. 3.1: XLR connector
Fig. 3.2: ¼" TRS connector
XENYX XL1600/XL2400/XL3200
Fig. 3.4:
Fig. 3.5:
Installation
Fig. 3.3: ¼" TS connector
Insert send/return stereo plug
¼" headphones connector
Fig. 3.6: RCA cable
7