Table of Contents
Advertisement
Table installation
300 mm
Space
100 mm
Space
Installation
D Two persons are required to remove the plasma TV from the packing. Never lift the display alone. Any
attempt to lift the display alone will pose a risk to your health.
D Place the display on a stable, horizontal base. The base must be solid and capable of bearing the load.
D Before installing it, make sure that the display is switched off and that the mains cable and signal cable
are unplugged.
Wall mounting
D The plasma TV screen may be mounted on vertical walls only.
D Before mounting it check whether the loadbearing capacity of the wall is suitable for 3-times the weight
of the plasma display screen (for the weight see page 44 "Technical Specifications"). If in doubt, seek
the advice of a qualified installer.
D Before installing it, make sure that the display is switched off and that the mains cable and signal cable
are unplugged.
D Two people are required to mount the display screen on the wall.
ENGLISH
100 mm
Space
. Turn the plasma TV screen so that the front side (screen)
Holes for
. Loosen the 6 screws that fasten it to the table foot and re-
brackets
. Fit the 2 fastening hooks (rawl plugs and fastening hooks
Ø min. 6,5mm
Screws
from
. Position the plasma TV screen so that the fastening hooks
the table foot
Wall mounting
800 mm Space
100 mm Space
is pointing downwards and place it on a completely flat and
firm surface.
move these.
are not included in the items supplied) horizontally and with
the appropriate distance between them (for this distance
see drilling template in the accessories pack) to the wall.
The fastening material must be designed for 3-ti-
mes the weight of the plasma display screen. If
necessary, please consult a qualified installer.
can be introduced into the openings provided for this pur-
pose on the rear side of the appliance.
Getting started
100 mm
Space
11
Advertisement
Table of Contents
