Technical Specifications; Installation; Positioning - Electrolux ER 6430 U Installation And Instruction Manual

TECHNICAL SPECIFICATIONS

DIMENSIONS
POWER SUPPLY VOLTAGE AND FREQUENCY
TOTAL POWER ABSORBED
AVERAGE DAILY UNITS ELECTRICITY
GROSS CAPACITY
NET CAPACITY
(*)This figure is based on standard test results in accordance with European Standard EN153. Actual con-
sumption will depend on how the appliance is used and where it is located.

INSTALLATION

Positioning

This appliance should only be installed at a location
where the ambient temperature corresponds to the
climate classification indicated on the rating plate,
which is located on the inside left of the appliance.
The following table shows which ambient temperature
is correct for each climate classification.
SN +10°C to +32°C
ST +18°C to +38°C
The appliance should be located in a dry atmosphere,
out of direct sunlight and away from continuous heat
and extreme temperature, e.g. not next to a boiler or
radiator, or in a very cold room e.g. an outhouse. If
these temperatures are exceeded i.e. warmer or cold-
er, then the appliance may not operate correctly.
For building-in and door reversal instructions please
refer to the relevant instructions on the following
pages.
(*)
13
Height 81,5
Width 59,6
Depth 54
220-240 V / 50 Hz
70 W
0,47 kWh
142 l
140 l
cm
cm
cm