Serial Ata Connector [Sata1] - Abit BH7 User Manual

Hardware Setup 2-13

(12). Serial ATA Connector [SATA1]

This connector provides one serial ATA device connection through Serial ATA cable. It is also possible
to connect legacy IDE hard disk through an optional SERILLEL2 Converter.
NOTE: To enable this SATA function, the "SATA Controller" option in the BIOS menu must be set to
[Enabled] in advance. By enabling this function, the "IDE2 Master" channel will then be disabled,
leaving only the "IDE2 Slave" channel available.
Do not forget to set the BIOS "SATA Controller" option back to [Disabled] if this SATA1 connector is
not attached with any Serial ATA device, otherwise, the "IDE2 Slave" channel will not be detected
during system boot up.
User's Manual