Sleep Timer Function; Checking The Current Time; Switching The Display's Brightness - Marantz M-CR510 Owner's Manual

Contents

Sleep timer function

You can have the power automatically switched to standby once a set
time has elapsed. This is convenient for listening while going to sleep.
1
Press SLEEP and display the time you want to set.
• The indicator on the display lights.
OFF
• You can set the sleep timer in the range from 10 to 90 minutes in
steps of 10 minutes.
2 To cancel the sleep timer
Press SLEEP to set "Sleep 1 Off".
The indicator on the display turns off.
OFF
%
• The sleep timer is also cancelled when this unit is set to the standby mode.
• To check the time remaining until the sleep timer is activated, press SLEEP.
Front panel Rear panel
Connections Playback
Remote
Settings

Checking the current time

2 Checking the current time when the power is
on
Press CLOCK.
• Press once more and the display returns to its original condition.
2 Checking the current time when the power is
set to standby
Press CLOCK.
• When "Network Control" (vpage 74) is set to "On", the current
time is displayed during standby.
Press CLOCK again, and the current time disappears.
• When Network Standby is set to "Off", the current time is displayed
for approximately 30 seconds, and then automatically disappears.
NOTE
• The time cannot be set when in the standby mode. Turn on the power first.

Switching the display's brightness

1
Press DIMMER.
• The display brightness is adjusted each time DIMMER is pressed.
100% (Default) / 75% / 50% / 25% / Off
%
• If you operate the buttons when the display's brightness is set to "Off", the display
temporarily lights at the 25% brightness level.
64
Index
Tips Appendix