GE Monogram ZEM200WV Installation Instructions Manual

Under cabinet installation and jx827wn built-in kit
Hide thumbs Also See for Monogram ZEM200WV:

Advertisement

Quick Links

GE Monogram
Installation
Instructions
Under Cabinet Installation
and
JX827WN Built-In Kit

Microwave Oven

Model
ZEM200WV
®

Advertisement

Table of Contents
loading

Summary of Contents for GE Monogram ZEM200WV

  • Page 1: Microwave Oven

    ® GE Monogram Installation Instructions Under Cabinet Installation JX827WN Built-In Kit Microwave Oven Model ZEM200WV...
  • Page 2: Table Of Contents

    Dimensions and Clearances ... 3 Installation Options ... 3 Advance Planning ... 3 Cabinetry ZEM200WV In-Wall Installation ... 4 ZEM200WV with Single Oven ... 5 ZEM200WV Under-Cabinet Mounting ... 5 Installation Preparation Electrical Supply ... 6 ZEM200WV In-Wall Installation ... 6, 7 ZEM200WV Under-Cabinet Mounting ...
  • Page 3: Design Information

    Refer to “Cabinetry” for complete details on prepara- planning tion for in-wall installation. If you wish to mount the ZEM200WV beneath a cabinet: • Cabinet must be wood or metal, in good condition. • Cabinet bottom must be capable of supporting an additional 90 pounds.
  • Page 4: Zem200Wv In-Wall Installation

    • 2" x 4" lumber • Saw • Screws and screwdriver or other hardware for construction of plywood base. Opening for model ZEM200WV must be: • 24 -7/8" • 15" 1/16" high. • With approximately 1-1/4" for oven trim overlap around all edges of opening.
  • Page 5: Zem200Wv With Single Oven

    “Installation” for details. ZEM200WV Under-cabinet mounting The ZEM200WV may be installed under virtually any cabinetry and is supplied with all hardware necessary for under-cabinet installation. Cabinet bottom must be capable of supporting an additional 90 pounds. Refer to “Advance Planning” for more details.
  • Page 6: Installation Preparation

    Monogram microwave ovens require a 120 volt, 60 Hz power supply, protected by a time delay fuse or circuit breaker. ZEM200WV oven is supplied with a power cord 57" long for which a properly grounded 3-prong electrical receptacle is required.
  • Page 7: Zem200Wv Under-Cabinet Mounting

    ZEM200WV • When cabinet depth is a critical factor, receptacle In-wall should be installed in a side wall at rear of opening: installation – 14 -5/8" minimum cabinet depth is required. (continued) • If receptacle is located behind oven, install receptacle flush with wall to minimize depth: –...
  • Page 8: Zem200Wv In-Wall Installation

    JX827WN Tools and materials installation required: • Accessory kit JX827WN for in-wall installation of ZEM200WV • 2 Phillips head screwdrivers (#1 & #2) •Drill and 3/32" drill bit • Centerpunch or nail • Pencil and ruler JX827WN Parts List 1. Base Pan 2.
  • Page 9: Jx827Wn Installation

    JX827WN installation • Remove the four top plug buttons from the top of the microwave oven cabinet. • Place the microwave oven on the base pan centered left to right. Do not tighten screws until all screws are started. Note: •...
  • Page 10 Caution: power cord. • Plug the power cord into the wall receptacle. • Gently slide the microwave oven assembly into the cabinet opening, keeping it centered. • Push to the back, allowing tongues of rear brackets to slide through rear slots.
  • Page 11: Assemble Trim Kit Frame

    Assemble • Assemble top, bottom trim kit and side trims with four frame screws D, as illustrated. When assembled, top, bottom and side strips must be flush. Bottom trim has a hinge Note: notch and is not interchangable with top trim. Install trim kit frame...
  • Page 12: Zem200Wv Under-Cabinet Mounting

    ZEM200WV Tools and materials Under-cabinet required: mounting • Flat-blade screwdriver • Phillips screwdriver • Drill and 1/4" bit • Nail or center punch • Pencil and ruler • Scissors • Hammer • Tape • Line cord holder (supplied) • Two brackets (supplied) •...
  • Page 13: To Drill From Bottom

    – Tape remaining portion of Template 2 in place. Installation Microwave Oven • With template secured in place, check again that hole center lines on Template 2 are straight, and that distance from right to left hole center measures...
  • Page 14: Finalize Under-Cabinet Installation

    Finalize under-cabinet installation 13/16" • With template secured in place, check again that hole center lines on Template 2 are straight, and that distance from right to left hole center measures distance shown on template. • Drill mounting holes: – Use of safety glasses is recommended to protect the eyes.
  • Page 15 Notes Microwav e Ovens...
  • Page 16 Monogram. ® General Electric Company Louisville, KY 40225 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. To obtain specific information concerning any Monogram product or service, call GE Answer Center consumer information service at 800.626.2000—any time, day or night.

This manual is also suitable for:

Monogram jx827wn

Table of Contents