Charging The Battery - Polaroid t730 User Manual

Charging the Battery

Using the AC power adapter may charge the battery or operate the camera as power
supply. Make sure that the power of the camera is off and then insert the battery
before starting.
1. Connect one end of the adapter to the
end of the AC power adapter.
The camera need to be power off when
charging the battery.
2. Insert the other end of the adapter
to the PC/AV terminal on the camera.
3. Insert the other end of the AC power adapter
into a wall outlet.
The status LED turns green when charging
is started and lights off when charging is
completed. The LED turns red when a
charging error has occurred or no battery
is inserted inside the camera.
It is recommended to fully discharge the
battery before recharging.
Charging time varies according to the
ambient temperature and the status of
battery.
This camera must be used with specified AC power adapter. Damage caused
by the use of an incorrect adapter is not covered under the warranty.
Always make sure that the camera is off before removing the battery.
The battery may feel warm after it has been charged or immediately after
being used. This is normal and not a malfunction.
When using the camera in cold conditions, keep the camera and battery
warm by storing it in a warm place such as an interior pocket between shots.
If you open the battery cover without removing the battery, the battery
power will not be disconnected.
If you remove the battery, you have to insert the battery within 2 hours in
order to make sure that the date and time will not be reset.
When charging the battery, do not place the camera in a high temperature
condition in direct sunshine or a heat source.
2
1
3
EN-15