Master/Slave Configuration - American DJ DOTZ MATRIX User Instructions

Dotz Matrix
2. 1 of 5 dimming curve settins will be displayed: Standard, Stage,
TV, Architectural, or Theatre. Use the UP and DOWM buttons to
select your desired dimming curve and press ENTER to confirm.
Dotz Matrix
Beam angle 60°
Field angle 80°
Intensity(LUX)
Red LEDs 2130 681
Green LEDs 3050 793
Blue LEDs 4730 1405
Full LEDs 10140 2630
4
3
2
1
0
1
2
3
4
0 1 2
60° Diameter(m) 2.65
80° Diameter(m) 3.65
ADJ Products, LLC - www.adj.com - Dotz Matrix User Manual Page 10
System Menu
Photometrics
302 197 136
398 246 173
716 368 224
1360 730 476
60 80
3 4 5
3.75 4.90 6.05
5.33 7.00 8.70
Dotz Matrix
Universal DMX Control: This function allows you to use a Elation®
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs. The Dotz Matrix has 5
DMX channel modes; a 3 Channel Mode, 6 Channel Mode, 7 Channel
Mode, 48 Channel Mode, & 52 Channel Mode. To select your channel
mode see page 8.
1. This function will allow you to control each individual fixture's
traits with a standard DMX 512 controller such as the
Elation® Show Designer™ or the Elation® DMX Operator.™
2. To run your fixture in DMX mode, follow directions on page 8 to
set your DMX address and DMX Channel mode.
3. Plug in the fixture via the XLR connections to any standard DMX
controller.
4. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
Dotz Matrix
Master-Slave Operation: This function will allow you to link up to 16
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units together
via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector is
the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit set your desired operating mode.
3. On the slave units press the MODE button until "Slave Mode" is
displayed.
4. The slave units will now follow the Master unit.
ADJ Products, LLC - www.adj.com - Dotz Matrix User Manual Page 11
Universal DMX Control
Master-Slave Configuration