Huskee 1032822 Owner's Manual page 10

STEP 3: Attach the tongue assembly (5) to the tank assembly (4) using two 1/2" NC x 4-1/2" hex cap bolts (1), two 1/2"
lock washers (2) and two and two 1/2" hex nuts. Tighten. (3).Tighten.
ITEM NO
1
2
3
4
5
O/L- Obtain locally. Common fasteners available through hardware
and farm stores.
STEP 4: Stand the beam (1) up on end. Two people may be needed for this step to ensure safety. Make sure that the
beam is stable and on a level surface.Remove the pivot pin (2) and clip pin (3) from the tank assembly.Roll the
tongue/ tank assembly into position between the two tabs on the beam (1). Slide the pivot pin (2) through the
aligned holes and lock in place with the clip pin (3)
ITEM NO.
1
2
3
O/L- Obtain locally. Common fasteners available through hardware
and farm stores.
Page 8
4
5
PART NO. DESCRIPTION
O/L 1/2"NC x 4-1/2" Bolt
O/L 1/2" Lock Washer
O/L 1/2" NC Hex Nut
401102R22 Tank Assembly
401102RC22 Tank/Assembly (CA)
40126300 Tongue Assembly
PART NO. DESCRIPTION
401613R0 Beam Assembly
071022WC Pivot Pin
O/L 1/2"-3/4" R Clip Pin
QTY.
2
2
2
1
1
1
QTY.
1
1
1