Tire Pressure - Cub Cadet Big Country 640 Operator's Manual

If the vehicle has not been put into use for an extended
period of time, charge the battery with an automotive
type 12-volt charger for a minimum of one hour at six
amps.
Replacing Headlights
Headlights
• Remove the two screws from the each headlight
housing located behind each fender.
• Remove the headlight lens and housing from the
front. The lens and the housing are connected.
See Figure 15.
• Twist the plastic connector and pull out light
assembly.
• Disconnect light bulb assembly from wire connector
and replace with new bulb assembly.
• Reassembly in reverse order.
Figure 15
Replacing Warning Lights
• Raise hood to get access to under the dash panel.
• Remove the appropriate bulb socket and replace
bulb.
• Reattach socket and lower hood. Secure hood to
fender.
Fuses
• Raise hood to get access to under the dash panel.
• Remove the appropriate electrical fuse and replace
with proper amperage fuse.
• Reattach socket and lower hood. Secure hood to
dash.

Tire Pressure

WARNING: Explosive separation of tire and
rim parts is possible when they are serviced
incorrectly. Do not stand in front or over tire
assembly when inflating.
The recommended operating tire pressure is approxi-
mately 5-6 psi for both the front and rear tires.
Overinflating above recommended tire pressure can
reduce the life of the tire. Check tire pressure before
driving the vehicle.
Wheel Replacement
Rear Wheels
•
•
•
Headlight Lens
& Housing
•
•
•
•
•
Front Wheels
•
•
•
•
•
•
•
IMPORTANT:
bearing damage.
14
WARNING: Using an unstable lifting device
and vehicle support may result in bodily injury.
Use a safe lifting device and supports to work
on raised vehicle.
Stop the vehicle on a level surface and apply
parking brake.
Turn the ignition key to the STOP position and
remove the key.
Loosen but do not remove the five wheel bolts from
the axle hub. See Figure 16.
Figure 16
Raise rear of vehicle with a safe lifting device and
place support stands under vehicle.
Remove the five wheel bolts and rear wheel. Place
new wheel on the axle hub and secure with bolts.
Tighten wheel bolts diagonally until snug.
Remove support stands and lower vehicle.
Finish tightening the bolts to 55-60 lb-ft using a
torque wrench.
Stop the vehicle on a level surface and apply
parking brake.
Turn the ignition key to the STOP position and
remove the key.
Remove plastic hub cap and loosen 16 x 40 cap
screw.
Raise front of vehicle with a safe lifting device and
place support stands under vehicle.
Remove cap screw and front wheel. Place new
wheel on front axle hub and secure with cap screw.
Remove support stands and lower vehicle.
Finish tightening the 16 x 40 screw to 80-85 lb-ft
using a torque wrench.
Overtightening front wheel can result in
Wheel Bolts