To Clean The Burner Head; To Reassemble The Burner Head; Side Burner Exploded View - Weber Platinum II 2200 LP Operating Manual

SIDE BURNER MAINTENANCE

To Clean the Burner Head

Remove the windshield and grate. Remove the burner
cap. Figure 19 (a). Clean with soap and water. Soak if
necessary.
Remove the burner ring. Figure 19 (b). Clean with soap
and water. Soak if necessary.
CAUTION: Do not enlarge the slots in the burner ring.
Only clean with a cloth and soap and water.
Remove the burner head. Figure 19 (c). Clean with soap
and water. Soak if necessary.
Wipe out the burner base with a damp cloth and soap
and water.
CAUTION: Avoid getting water or dust in the burner
orifice.
Clean the ignition electrode with a damp cloth and soap
and water.
Windshield
Burner cap
Grate
Figure 19
Burner head
Burner base
(a)
(b)
Lugs
Slots
(c)
Burner orifice

To Reassemble the Burner Head

Insert the burner head into the burner base. Figure 19 (c).
There is a hole in the burner head for the igniter electrode.
Set the burner ring onto the burner head. Rotate the
burner ring until the four lugs on the burner ring are
seated in the four slots on the burner head. Figure 19 (b).
WARNING: If the flame pattern is uneven or erratic,
turn OFF the burner control knob. Check the position
of the burner ring to the burner head. The lugs of the
burner ring must be in the slots of the burner head.
Install the burner cap. Figure 19 (a). Install the grate and
the windshield.
SIDE BURNER
EXPLODED VIEW
Burner ring
Lug
Slot
Burner assembly consists of: burner cap, burner ring,
burner head, burner base, and burner orifice.
Note: The burner head has a hole in it that fits over the
igniter electrode.
17
Windshield
Grate
Burner cap
Burner ring
Burner head
Igniter electrode
Burner base
Burner orifice