GE Autotrol Performa ProSoft 960 Series Installating And Operation Manual page 15

Table 8 - Performa 960 FA Level II Programming Parameters
Parameter
Range of Values
Name Description
P6 Refill controller
Regenerant draw
P7
value
P8 Not used
P9 Backwash time
P10 Slow Rinse time
P11 Fast Rinse time
P12 Units of measure
P13 Clock mode
Calendar
P14
override
P15 Reserve type
Fixed reserve
P16 capacity or initial
average value
P17 Operation type
Regen. Dosage/
P18 Capacity change
lock out
P19 Factory defaults
Minimum
Default
Increments
1 to 99 1
1 to 99 1
NA NA
3 to 30 1
8 to 125 1
2 to 19 1
0 to 1 1
0 to 1 1
0 to 30 1
0 to 3 1
0 to 70 1
0 to 2 1
0 to 1 1
0 to 3 1
Units of Measure
33
25
NA NA
14 Minutes
40 Minutes
4 Minutes
0
0
0 Days
0
30 Percent of capacity
2
0
99
15
Notes
Must be set to 46 for Performa 960
FA operation
Select Regenerant Draw value from
Table 9 and enter that number.
NA
Skip this parameter to accept the
default or enter a value.
Skip this parameter to accept the
default or enter a value.
Skip this parameter to accept the
default or enter a value.
0 = U.S., 1 = Metric. Skip this
parameter to accept U.S. or enter 1
for Metric.
0 = 12-hour clock, 1 = 24-hour
clock. Skip this parameter for a 12-
hour clock or enter 1 for a
24-hour clock.
0 = no calendar override. Skip this
parameter for no calendar override
or enter a value.
0 = variable reserve, 1 = fixed
reserve, 2 = variable reserve with
immediate regen, 3 = fixed reserve
with immediate regen. Skip this
parameter to accept the default or
enter a different reserve type.
Description depends on the value
entered for P15. Skip this
parameter to accept the default or
enter a different value.
2 = 5 cycle Cocurrent conditioner
0 = none, 1 = Regenerant Dosage/
Capacity change locked out. Skip
this parameter to accept the
default or enter 1 to lock out
Regenerant Dosage/Capacity
change.
Loads in factory default values. Do
not change this parameter.