Connecting Front Panel Cable - AOpen i945Ga-PLF User Manual

Connecting Front Panel Cable

Attach the power LED, speaker and reset switch connectors to the corresponding
pins. If you enable "Suspend Mode" item in BIOS Setup, the ACPI & Power LED
will keep flashing while the system is in suspend mode.
Locate the power switch cable from your housing, which is a 2-pin female
connector from the housing front panel. Plug this connector to the soft-power
switch connector marked SPWR.
1
NC
NC
+5V
HDD LED
HDD LED
+5V
+5V
GND
NC
SPEAKER
Front Panel Connector
Power Switch
GND
Power LED-
GND
Power LED+
NC
GND
GND
RESET
GND
16