Dimplex DS5598 Service Manual page 11

tween the end of the connector and the heater to release the
wires.
19. Properly orient the new heater assembly and connect all
of the wiring clips and connections.
20. Reassemble in the reverse order as above.
Mod C and Higher
Tools Required: Philips head screwdriver
Flat head screwdriver
WARNING: If the fireplace was operating prior to servic-
ing, allow at least 10 minutes for light bulbs and heating ele-
ments to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Remove the stove pipe kit (if equipped).
2. With the front door closed, gently place the stove, door
side up on a flat surface.
3. Remove the heater assembly retaining screws located
on the bottom of the stove with a screwdriver.
4. Lower the heater assembly off of the bottom of the stove
being careful not to damage any of the wiring.
5. Disconnect the wiring clips and connections noting their
original locations.
!
NOTE: Use a flat head screwdriver to gently pry be-
tween the end of the connector and the heater to release the
wires.
6. Remove the heater assembly mounting screws and
remove the heater assembly.
7. Properly orient the new heater assembly and connect all
of the wiring clips and connections.
8. Reassembly in the reverse order as above.
11