Advertisement
Problem
The display on the front
panel does not light up.
No sound or picture, but the
front panel shows red light.
No sound or picture.
Bad picture / blocking
error.
The picture is not
showed on the screen,
when switching on.
There is interference on
your digital satellite
channels, an existing
terrestrial channel or video
signal.
The RCU is not working.
Note : If you have tried all of the actions suggested above, without solving the
problem, please contact your dealer or service provider.
13
Possible causes
Main cable is not connected.
The
receiver
is in standby mode.
The satellite dish is not pointing at the
satellite.
No signal or weak signal.
The satellite dish is not pointing at
the satellite.
Signal is too strong.
Satellite dish is too small.
LNB noise factor too high.
The LNB is faulty.
The system is connected by RF
leads.
The system is connected by RF
leads and the output channel of the
receiver interferes with an existing
terrestrial channels or Video signal.
Battery exhausted.
RCU is incorrectly aimed.
What to do
Check that the main cable is plugged into
the power socket.
Press the standby button.
Adjust the dish. Check the signal
level in the Antenna Setup menu.
Check the cable connections, LNB and
other equipment connected between the
LNB and the receiver, or adjust the dish.
Adjust the dish.
Connect a signal attenuator to the LNB
input.
Change to a larger dish.
Change to an LNB with lower noise
factor.
Change the LNB.
Check the UHF channel fixed in your
system and tune the UHF channel
properly.
Change the
receiver
output channel to
a more suitable channel, or connect the
system by SCART leads.
Change the batteries.
Aim RCU at the
receiver
, or check that
nothing blocks the front panel.
Advertisement
