Zone2; Connecting Zone 2; Zone 2 Out Settings - Integra DTR-4.9 Instruction Manual

Zone 2
In addition to your main listening room, you can also enjoy playback in the other room, or as we call Zone 2. And, you
can select a different source for each room.

Connecting Zone 2

Connecting Your Zone 2 Speakers to an
Amp in Zone 2
This setup allows 5.1-channel playback in your main lis-
tening room and 2-channel stereo playback in Zone 2,
with a different source in each room.
Hookup
• Use an RCA audio cable to connect the AV receiver's
ZONE 2 PRE OUT L/R jacks to an analog audio input
on your Zone 2 amp.
• Connect your Zone 2 speakers to the speaker termi-
nals on your Zone 2 amp.
Main room
Zone 2
R
Notes:
• The Zone 2 volume must be set on the Zone 2 amp.
• If you're using a power amp with no volume control in
Zone 2, you must set the Zone 2 Out setting to Variable
(see right column).
66
TV
AV receiver
ZONE 2
PRE OUT
L
R
IN
L
Receiver/
integrated amp

Zone 2 Out Settings

If you've connected your Zone 2 speakers to an amp with
no volume control, set the Zone 2 Out setting, respec-
tively, to Variable so that you can set the zone's volume,
balance, and tone on the AV receiver.
On/Standby
Input
Selector
Enter
Setup
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
2
Use the Up and Down [
buttons to select "7. Hardware
Setup," and then press [Enter].
3
Use the Up and Down [
buttons to select "Zone 2" and
then press [Enter].
4
Use the Up and Down [
buttons to select "Z2 Out" and
use the Left and Right [
buttons to select:
Fixed: The Zone 2 volume must be
Variable: The Zone 2 volume can be

Zone2

Receiver
]/[ ]
]/[ ]
]/[ ]
]/[ ]
set on the amp in that zone.
set on the AV receiver.