Table of Contents
Advertisement
C38-BV Gas Fireplace
Wiring
Gas Control and Pilot Wiring
Honeywell (Q3450)
Pilot Assembly
Pilot Electrical
Harness Connector
Honeywell Gas
Control (SV9501M)
Gas Control
Connector
Fan Plug
Receptacle
Grnd Screw
Limit
Wall
Switch
Switch
Figure 8. Wiring for the C38-BV-I with Honeywell gas control and
pilot.
Removing and Installing
the Door
Removing the Door:
Remove the trim (as described on the next page) to access the door
latches. Open the latches by pulling Part A upwards and towards
you to disengage Part B from the door. Lift Part B clear of the door.
Repeat for all three latches. Be sure to hold the door carefully so it
does not fall. (See figure 9a.)
Figure 9a. Operating the door latches.
Page
Installation
C38-BV-I
Junction Box Cover
Fuse
Junction Box
Black
115VAC
Green
24VAC
40 VA
Transformer
Figure 9b. Removing the door.
White
Once the three latches are unhinged, tilt the top of the door forward
and lift it out of the slots. See figures 9b and 9c.
Figure 9c. Removing the door.
Re-installing the door:
To re-install the door, tilt the top edge towards you and line up the
tabs of the bottom of the door with the slots on the fireplace. Place
the tabs into the slots, and tilt the top of the door back towards the
fireplace as far as it will go. Close the latches by hooking Part B onto
the groove at the top of the door and pushing Part A down completely.
Part No. XG0314
Advertisement
Table of Contents
