INSTRUMENT AND CONTROL FUNCTIONS
and do not keep more than one
immobilizer key on the same key ring!
Immobilizer system keys may cause
signal interference, which may pre-
vent the engine from starting.
2. If the engine starts, turn it off, and
try starting the engine with the
3
standard keys.
3. If one or both of the standard
keys do not start the engine, take
the vehicle, the code re-registe-
ring key and both standard keys
to a Yamaha dealer and have the
standard keys re-registered.
If the multi-function display indicates
any error codes, note the code num-
ber, and then have a Yamaha dealer
check the vehicle.
Clock mode
To set the clock:
1. Push the "SELECT" button and
"RESET" button together for at
least two seconds.
2. When the hour digits start flas-
hing, push the "RESET" button to
set the hours.
3. Push the "SELECT" button, and
the minute digits will start flas-
hing.
4. Push the "RESET" button to set
the minutes.
5. Push the "SELECT" button and
then release it to start the clock.
3-10
Ambient temperature display
Pushing the "SELECT" button for at
least two seconds switches the clock
display to the ambient temperature
display. This display shows the
ambient temperature from –10 °C to
50 °C in 1 °C increments. The tempe-
rature displayed may vary from the
ambient temperature. Pushing the
"SELECT" button for at least two
seconds switches the ambient tem-
perature display to the clock display.
TIP
G
If the ambient temperature falls
below –10 °C, a lower temperatu-
re than –10 °C will not be displa-
yed.
G
If
the
ambient
temperature
climbs above 50 °C, a higher
temperature than 50 °C will not
be displayed.
G
The accuracy of the temperature
reading may be affected when
riding
slowly
(approximately
under 20 km/h (12.5 mi/h)) or
when stopped at traffic signals,
railroad crossings, etc.