Self-Diagnosis Device - Yamaha TMAX XP500A Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
V-belt replacement indicator "V-BELT"
flashes (i.e. before the periodic V-belt
change interval has been reached), the
indicator "V-BELT" must be reset after
1 the V-belt change for the next periodic
V-belt change to be indicated at the
correct time.
2
The electrical circuit of the indicator can
be checked according to the following
3
procedure.
1. Turn the key to "ON" and make
sure that the engine stop switch is
4
set to " ".
2. If the V-belt replacement indicator
5
does not come on, have a Yamaha
dealer check the electrical circuit.
6

Self-diagnosis device

7
8
9
1
1. Error code display
This model is equipped with a self-diag-
nosis device for various electrical cir-
cuits.
If any of those circuits are defective, the
engine trouble warning light will come
on, and then the display will indicate a
two-digit error code.
This model is also equipped with a
self-diagnosis device for the immobiliz-
er system.
If any of the immobilizer system circuits
are defective, the immobilizer system
indicator light will flash, and then the
display will indicate a two-digit error
code.
NOTE:
If the display indicates error code 52,
this could be caused by transponder in-
terference. If this error code appears,
try the following.
1. Use the code re-registering key to
start the engine.
NOTE:
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
3-10
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
If the display indicates any error codes,
note the code number, and then have a
Yamaha dealer check the vehicle.
CAUTION:
If the display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.
ECA11590