Chapter 2 Standard Operations
2.2 Attaching and Removing the Flange Cover
Procedure
1
2
2.2
Attaching and Removing the Flange Cover
This section explains how to attach and remove the flange cover of the 2.5" type controller
enclosure.
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Press and hold the console panel's power switch ( ) for 4 seconds or longer.
The READY LED should turn off.
Press the Power switch only once. If the Power switch is pressed
IMPORTANT
again while either the POWER LED or the READY LED is on, the
ETERNUS DX Disk storage system power may turn on.
Power switch
The ETERNUS DX Disk storage system power is turned off.
When the power is turned off, the POWER LED will go out.
When drive enclosures are installed, the power turns off
automatically.
Do
CAUTION
•
At the completion of this operation, check that the flange cover is
attached.
Copyright 2013 FUJITSU LIMITED
Drive Enclosure
Controller Enclosure
35
End of procedure
P3AM-5512-05ENZ0