Advertisement
BASIC SHREDDING OPERATION
Continuous operation:
Up to 8-minutes maximum
NOTE: Shredder runs briefly after each pass to
clear entry. Continuous operation beyond 8-minutes
will trigger 15-minute cool down period.
ADvANCED PRODUCT FEATURES
SafeSense
Technology
®
Stops shredding immediately when
hands touch the paper opening.
SilentShred™ Technology
Shreds without noisy disruptions
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
All micro-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding, and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
2
Press and hold forward
*Apply oil across entry
( ) 2-3 seconds
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain
illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery
time for this shredder.
SafeSense
®
Indicator: If hands are too close to the paper entry, the SafeSense
PAPER/CARD OR CD
1
2
Plug in and
Feed paper/card
turn ON (I)
straight into paper
entry and release
SET-UP AND TESTING
1
Turn the shredder ON
(I) to activate SafeSense
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare
occasions the sensors may become blocked by paper dust causing the motor to run even if there
is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
Turn OFF (O) and
unplug shredder
15
®
indicator will illuminate and the shredder will stop shredding.
or
Hold CD at edge,
When finished
feed into center of
shredding set to OFF (O)
entry and release
SAFESENSE
TECHNOLOGY
®
Stops shredding immediately when hands touch the paper opening.
2
Touch test area and
look for the SafeSense
®
®
indicator to illuminate
2
Locate Auto-start
infrared sensor
3
3
SafeSense
is active and
®
working properly
.
4
3
Dip cotton swab in
Using cotton swab, wipe
rubbing alcohol
away any contamination
from the paper sensors
Advertisement
