Before You Call For Service - GE 175D1807P252 Owner's Manual

Before you call for service...

Troubleshooting Tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Problem
Washer won't operate
Water temperature
is incorrect
Water won't drain
Water leaks
Washer is noisy
Washer pauses in cycle
Clothes too wet
8
Possible Causes
Washer is unplugged
Water supply is turned off
Controls are not set
properly
Lid is open
Circuit breaker/fuse is
tripped/blown
Control is not set properly
Water supply is turned off
or improperly connected
Water valve screens are
stopped up
House water heater is
not set properly
Drain hose is kinked or
improperly connected
Fill hoses or drain hose is
improperly connected
Household drain may
be clogged
Constant water pressure
to the fill hoses at the
water source
Washer is uneven
Washer load is
unbalanced
The washer normally pauses
between washing steps
Incorrect cycle selected
What To Do
• Make sure cord is plugged securely into a working outlet.
• Turn both hot and cold faucets fully on.
• Check controls and make sure Cycle knob is pulled out
to ON position.
• Close lid and pull Cycle knob out to ON position.
• Check house circuit breakers/fuses. Replace fuses or
reset breaker. Washer should have separate outlet.
• Check water temperature control and adjust.
• Turn both hot and cold faucets fully on and make sure
hoses are connected to correct faucets.
• Turn off the water source and remove the water
connection hoses from the upper back of the washer.
Use a brush or toothpick to clean the screens in the
machine. Reconnect the hoses and turn the water
back on.
• Make sure house water heater is delivering water
at 120°F.–140°F.(48°C.–60°C.).
• Straighten drain hose and make sure washer is not
sitting on it.
• Top of drain outlet should be less than 8 ft. above floor.
• Make sure hose connections are tight at faucets and
make sure end of drain hose is correctly inserted in
and secured to drain facility.
• Check household plumbing. You may need
to call a plumber.
• Tighten hoses at the faucets and turn the water off
after each use.
• Check condition of the fill hoses; they may need
replacement after 5 years.
• Make sure washer is level and firm to the floor.
• Push the Cycle knob in to stop the washer, open the
lid and redistribute the load evenly. Close the lid
and restart.
• Make sure the cycle selected matches the load
you are washing.