Engine Oil Change; Wheel And Deck Zerks; Front Wheel Mount; Front Wheel Bearings - Husqvarna M-ZT52 Operator's Manual

Engine Oil Change

NOTE: Change the engine oil when the engine is warm.
Refer to the engine owner's manual for the correct
replacement oil and filter change recommendations.
1. Park on a level surface. Apply parking brake.
2. Clean the dirt and debris from the area around the
oil fill cap.
3. Remove the cap/dipstick.
4. Locate the drain hose at the left rear of the engine.
Place an adequately sized container under the
end of the drain hose and remove the oil drain
plug.
5. Allow the oil to fully drain from the engine.
6. Replace the drain hose plug and tighten securely.
7. Fill the engine with new oil to the bottom of the fill
tube threads. Check the level with the dipstick.
8. Replace the oil fill cap securely when the oil level
is FULL.
9. Refer to the Service Journal for oil checking and
changing intervals.

Wheel and Deck Zerks

Use only good quality bearing grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.

Front Wheel Mount

Lubricate with a grease gun until the grease is forced
out.

Front Wheel Bearings

Lubricate 3-4 strokes with a grease gun on each set of
wheel bearings.
46
LUBRICATION
WARNING!
To prevent burns, the engine should
be shut off and allowed to cool slightly
so the engine is still warm but the
surrounding surfaces and oil are not.
Oil change drain hose
Lubricating front wheels
8058-216
8058-068