Behringer GUITAR AMPLIFIER GTX30 Quick Start Manual page 7

12
GUITAR AMPLIFIER GTX60/GTX30
GUITAR AMPLIFIER GTX60/GTX30 Controls
(2) (7)
(1) (3) (4) (5) (6) (8) (9) (10)
(23)
(24)
(13) (22)
(11) (12) (14) (15) (16) (17) (18) (19) (21) (20)
(25) (26) (27) (28)
13
Quick Start Guide
Controls
The INPUT socket is the 1/4" connector for
(EN) (1)
your guitar. Please use a standard 1/4" TS connector.
The CLEAN CHANNEL LED lights up when the
(2)
channel is active.
The VOLUME control determines the volume of the
(3)
CLEAN channel.
The BASS control in the EQ section boosts or
(4)
cuts the bass frequencies on the CLEAN channel
(GTX60 only).
The TREBLE control adjusts the treble frequencies
(5)
on the CLEAN channel (GTX60 only).
Press the CHANNEL button to switch between the
(6)
CLEAN and OVERDRIVE channels. The channel LED
lights up when the channel is activated. You can
also switch between channels using the footswitch
sold with all models.
The OVERDRIVE CHANNEL LED lights up when the
(7)
channel is active.
The GAIN control determines the amount of gain
(8)
applied and hence the degree of distortion in the
OVERDRIVE channel.
The BASS control in the EQ section boosts or cuts
(9)
the bass frequencies.
Use the CONTOUR control for additional, highly
(10)
characteristic adjustment of the midrange, so as
to easily create traditional as well as ultra-modern
guitar sounds.
The TREBLE control adjusts the treble frequencies.
(11)
The VOLUME control adjusts the volume level of
(12)
the OVERDRIVE channel.
The FX LED lights up when the effects processor
(13)
is active.
Use the FX PRESET control to select one of
(14)
16 effects.
Preset
1 - 4
5 - 8
9 - 12
13 - 16
The FX LEVEL control adjusts the mix ratio
(15)
between the original and the effect signal.
The TUBE push button activates and deactivates
(16)
the VTC Virtual Tube Circuitry.
The CD IN connector allows you to connect
(17)
the output signal of a CD player, tape deck,
or CD/MD walkman.
The LINE OUT/PHONES jack is for
(18)
headphones connection.
Use the FOOTSWITCH jack to connect the 1/4" TRS
(19)
plug of the footswitch supplied with the unit.
The POWER switch turns your GUITAR COMBO
(20)
on and off.
The TUNER push button activates and deactivates
(21)
the integrated tuner.
The DISPLAY shows the note played.
(22)
This is the power cord.
(23)
SERIAL NUMBER.
(24)
This is the cooling vent.
(25)
The SPEAKER OUT jack (1/4" TS connector) is used to
(26)
connect to a loudspeaker. The minimum impedance
is 8 Ohms (GTX60 only).
The FX RETURN input is used to connect to the
(27)
output of an external effects unit with a shielded
1/4" TS connector (GTX60 only).
The FX SEND output is used to connect the
(28)
input of an external effects unit with a shielded
1/4" TS connector (GTX60 only).
Check Out behringer.com for Full Manual
FX
Reverb
Delay
Chorus
Flanger