Rear Panel - Rivera Quiana Studio Owner's Manual

on, always check that a speaker is connected and that the power cord is firmly plugged
into the amp and the outlet.

Rear Panel

MAINS INPUT
REPLACE FUSE WITH SAME TYPE AND RATING
MAINS H.T.
FUSE FUSE
TO REDUCE THE RISK OF ELECTRIC
SHOCK,DO NOT REMOVE CHASSIS
INPUT POWER
115V ~ 60Hz
3A 250V 500MA 250V
300 WATTS
SLO-BLO SLO-BLO
Mains Input
Your RIVERA amp has a detachable power cord that connects to the chassis AC
connector labeled Mains Input. Always use this cord and, in the event that the power
cord requires replacement, replace it with the same type of power cord. Consult your
RIVERA dealer for further information. Be sure to use a grounded electrical mains
power supply socket whenever possible. These outlets have a grounding pin in addition
to the normal line and neutral pin. The power cord supplied with your RIVERA amp has
a 3-pin plug. Do not cut off or damage the ground pin. If the available electrical outlet is
of the older 2-pin type, use a suitable ground-lift adapter.
The U.S.A., Canada, and Japan share a common CSA/UL-style cord. Most of Europe
and Scandinavia utilize a Euro plug and have a SEMKO/VDE-style cord. Australia uses
a different type of plug, as does England, and South Africa as well.
Note: Avoid using long power extension cords. Long cords have sufficient resistance to
electrical current that the voltage arriving at your amp can be significantly reduced. This
can have a bad effect on your tone.
Mains Fuse (50Watt-55Watt Quiana and Fandango models)
This AC line fuse protects your amplifier from damage due to shorts, momentary
surges, and defective power tubes. In the event of a fuse failure, always replace it with
the same type of fuse.
Note: Always turn the amp off and wait about five minutes before
replacing a fuse. This allows the parts to cool and high voltages to
dissipate.
For 100VAC versions, the Mains Fuse is:
3 Amp, 250 Volt Slo-Blo type (size 3AG, or MDL)
For 115VAC versions, the Mains Fuse is:
3 Amp, 250 Volt Slo-Blo type (size 3AG, or MDL)
For 230/250VAC versions, the Mains Fuse is:
T 1.6A (time-delay, 5mm x 20mm size)
VINTAGE / MODERN
CAUTION
SERIAL NUMBER
MODEL
QUIANA/FANDANGO
RIVERA RESEARCH & DEVELOPMENT CORP., SYLMAR, CALIFORNIA, USA
Quiana and Fandango 1.0 p 9
SPEAKER 1
SPEAKER 2 LINE OUT
FOOTSWITCH
USE FIRST 560
USE FS-7 ONLY
8
TOTAL MIN. Z 8 55 W. RMS
SPEAKER JACKS IN PARALLEL
IMPEDANCE
SELECTOR
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE
CAUTION: CHASSIS SURFACE HOT
THIS EQUIPMENT TO RAIN OR MOISTURE
CAUTION: NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL
EFFECTS LOOP
RETURN SEND
LEVEL LEVEL
RETURN SEND
1
1
Z IN Z OUT
250K 560