Programming For Cable - GE RM94940 Instruction Manual

94940 Revised Size 10/18/02

Programming For Cable

1. Manually turn on the Cable Box. Find the three
digit code for your Cable Box at the back of the
instructions.
2. Press and hold the
CODESEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release
the CBL/SAT button
(The INDICATOR
LIGHT will blink then
remain lit.
4. Enter the code
using the Number
Buttons. After your
code is entered, the
INDICATOR LIGHT
will turn off. If the code
is not valid, the INDICATOR LIGHT will blink. Check
the code list and repeat process.
5. Aim the remote at
your CABLE and press
the ON•OFF button.
Your CABLE should
turn off.
6. With your Cable
Box on, press CHAN+
(CHANNELUP). If
the Cable Box
responds, no further
programming is required.
NOTE: If your Cable Box does not respond, try all the
codes for your brand. If the codes do not work,
or your brand is not listed, try the Code Search
method on Page 12.
7. Enter your code here
for easy reference.
CABLE BOX
CODE LIST
12:22 PM Page 11
CBL/SAT
10