Conference Configuration - Cisco TelePresence System Codec C90 Reference Manual

Cisco TelePresence System Codec C90
Contents Introduction
xConfiguration Cameras Camera [1..7] DHCP
Applies to cameras which support DHCP over LAN. When set, the command enables support for
software upgrade of daisy chained cameras.
Requires user role: ADMIN
Value space: <Off/On>
Off: When the camera is not connected to a LAN, set to Off to disable DHCP.
On: Set to On to enable DHCP for the camera. The camera is automatically re-booted, and after
re-boot the camera's DHCP function will force start of MAC and IP address retrieval. To see the
result, you can run the following API command: "xStatus Camera". When the camera no longer is
connected to a LAN, set to Off.
Example: xConfiguration Cameras Camera 1 DHCP: Off
Codec C90 API Reference Guide TC7.0, JANUARY 2014.
D14641.15
About the API xConfiguration xConfiguration

Conference configuration

xConfiguration Conference [1..1] CallProtocolIPStack
xConfiguration Conference [1..1] AutoAnswer Mode
xConfiguration Conference [1..1] AutoAnswer Mute
36
xCommand
Select if the system should enable IPv4, IPv6, or dual IP stack on the call protocol (SIP, H323).
Requires user role: ADMIN
Value space: <Dual/IPv4/IPv6>
Dual: Enables both IPv4 and IPv6 for H323 and SIP calls.
IPv4: When set to IPv4, the call protocol (SIP, H323) will use IPv4.
IPv6: When set to IPv6, the call protocol (SIP, H323) will use IPv6.
Example: xConfiguration Conference 1 CallProtocolIPStack: Dual
Set the auto answer mode.
Requires user role: ADMIN
Value space: <Off/On>
Off: An incoming call must be answered manually by pressing the OK key or the green Call key on
the remote control, or by tapping the Accept key on the Touch screen control panel.
On: Enable auto answer to let the system automatically answer all incoming calls.
Example: xConfiguration Conference 1 AutoAnswer Mode: Off
Determine if the microphone shall be muted when an incoming call is automatically answered.
Requires that AutoAnswer Mode is switched on.
Requires user role: ADMIN
Value space: <Off/On>
Off: The incoming call will not be muted.
On: The incoming call will be muted when automatically answered.
Example: xConfiguration Conference 1 AutoAnswer Mute: Off
API Reference Guide
xStatus Appendices
Copyright © 2010–2014 Cisco Systems, Inc. All rights reserved.